[Amps] Why a voltage doubler ?
Carl
km1h at jeremy.qozzy.com
Sat May 13 20:59:23 EDT 2017
Capacitance is cheap these days so doubling that covers the issue.
Carl
----- Original Message -----
From: "Paul Baldock" <paul at paulbaldock.com>
To: "amps" <amps at contesting.com>
Sent: Saturday, May 13, 2017 7:32 PM
Subject: Re: [Amps] Why a voltage doubler ?
> Doesn't a full wave bridge give you better regulation as all capacitors
> are charged on both halves of the AC waveform, where as with a voltage
> doubler the capacitors are only charged on half the waveform (half on the
> positive and half on the negative)?
>
> - Paul
>
>
>
> At 03:55 PM 5/13/2017, Carl wrote:
>>The doubler had been used by hams since the 30's but made it into prime
>>time with QST articles aimed at the Novice and other money challenged
>>hams.
>>
>>National and Collins were early users and within a few years almost
>>everyone was doing it.
>>
>>Ameritron still lives in the last century.
>>
>>Carl
>>
>>
>>----- Original Message ----- From: "Richard Solomon" <dickw1ksz at gmail.com>
>>To: "amps" <amps at contesting.com>
>>Sent: Saturday, May 13, 2017 5:09 PM
>>Subject: Re: [Amps] Why a voltage doubler ?
>>
>>
>>>Actually, the Yankee Skinflint in me likes
>>>to think it had more to do with economics.
>>>
>>>Copper wire and winding time is expensive.
>>>
>>>73, Dick, W1KSZ
>>>
>>>On Sat, May 13, 2017 at 2:00 PM, Ron Youvan <ka4inm at gmail.com> wrote:
>>>
>>>> Paul Baldock wrote:
>>>>
>>>>Why did early amplifiers use voltage doublers rather than twice the
>>>>>secondary turns and a full wave bridge?
>>>>
>>>> I think it is for two reasons, to control the impedance of the power
>>>>supply and to limit the fault current, if there is an arc. (anywhere)
>>>>Then on rebuilds cheapskate HAMs double the value of the capacitors and
>>>>increase the fault current.
>>>>
>>>> Making the plate supply overly robust (and low impedance) increases
>>>> the
>>>>chances of a fault damaging things, if the supply caves in, hard damage
>>>>is
>>>>minimized.
>>>>The SB-220 plate power supply was the perfect design for two 3-500s
>>>>throttled back to 1,000 input watts. (then the limit)
>>>>--
>>>> Ron KA4INM - Youvan's corollary:
>>>> Every action results in unwanted side effects.
>>>>_______________________________________________
>>>>Amps mailing list
>>>>Amps at contesting.com
>>>>http://lists.contesting.com/mailman/listinfo/amps
>>>_______________________________________________
>>>Amps mailing list
>>>Amps at contesting.com
>>>http://lists.contesting.com/mailman/listinfo/amps
>>
>>
>>---
>>This email has been checked for viruses by AVG.
>>http://www.avg.com
>>
>>_______________________________________________
>>Amps mailing list
>>Amps at contesting.com
>>http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
More information about the Amps
mailing list