[Amps] SB200 on 30m
RAY FRIESS
rayfrijr at msn.com
Thu Oct 5 23:07:16 EDT 2017
Use the 10M band setting for 12, 15M for 17, and 20M for 30. Then, starting out with low drive power (about 10 watts) tune the amp like you would normally. The sweet spots on the Tune and Load cap knobs will be in strange places and may be kinda quirky but you should be able to load it up.
________________________________
From: Amps <amps-bounces at contesting.com> on behalf of jerome schatten <romers at shaw.ca>
Sent: Thursday, October 5, 2017 8:58 PM
To: amps at contesting.com
Subject: [Amps] SB200 on 30m
Hi…
On 30m using the 20m band-switch position, I’m able to get about 200w out into a dummy load/wattmeter before the grid current rises faster than the plate current. On 80/40 I can get over 400w out. Since I’m only interested in using the amp on 80/40/30, I thought to improve the 30m situation a bit by adding a few turns to the total pi-network inductance in the 20m position.
I’m willing to sacrifice a bit of efficiency on 80/40 to bring up 30 and sacrifice 20/15/10 entirely. The goal here would be 300+ watts on 80/40/30 with ease. I have already taken care of the input matching for 30 in the 20m position.
I would appreciate any suggestions.
Jerome - va7vv/ve7ass
Vancouver
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Amps Reflector - Contesting.com Ham Radio Mailing Lists<http://lists.contesting.com/mailman/listinfo/amps>
lists.contesting.com
Your email address: Your name (optional): You may enter a privacy password below. This provides only mild security, but should prevent others from messing ...
More information about the Amps
mailing list