[Amps] Ameritron Al-1500 excessived grid current & shut down

[w8hw]

90% of the time it is a diode on the hv board that is near the edge. If 
I were home, I could give you the exact one, but won't be home in 
Florida for a week (Sept 3). I repair amps and have worked on that 
problem on that exact amp many times, and only once was it the tube. 
Hope that helps. 73, Bruce, W8HW

On 8/26/2018 4:30 PM, Herbert Schoenbohm wrote:
> Today I turned on the Al-1500and immediately notice that the grid current
> went all the way over to the right and the amp grid protection circuit kick
> in.  Even with only 5 watts of drive, the grid current is about 175 ma.  I
> also notice that I don't see any HV indication.  I hope this is not a bad
> 8877 final tube. Any suggestion to confirm this would be appreciated.
>
> Thanks,
>
> Herb, KV4FZ
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps