[Amps] clipperton l low output on ssb

[Victor Rosenthal 4X6GP]

If you are looking at an average-reading power meter, then the output on 
SSB will look much lower than on CW because of the low duty cycle.
If your power meter has a peak-reading mode, that's what you need to see 
the real SSB output.
Another thought: is the zero-signal plate current normal on SSB?


73,
Victor, 4X6GP
Rehovot, Israel
Formerly K2VCO
CWops no. 5
http://www.qsl.net/k2vco/
On 19/02/2019 12:40, mike vititoe wrote:
> Ok I bought a clipperton l used unknown condition. I installed new harbach power supply board, new 572b tubes, resoldered some bad solder joints. I have 2700v pv and it is doing 1000w on cw but seems to only be doing 100w out on ssb. Have checked alc on radio and seems to be ok. Have swr of 1.1-1 I am stumped. Anyone have any ideas?
> 
> Mike
> K0ISP
> 
> Sent from Mail for Windows 10
> 
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>