[Amps] Cathode Choke

[Jim]

Spark gaps on the filament and cathode to ground also work well. 
Something rated to conduct at 50 volts will do the trick.


Thanks
73
Jim W7RY

On 10/5/2019 6:34 PM, Gary Schafer wrote:
> The choke in the filament circuit is there so that the cathode can be tied
> to one side of the filament. There is not much isolation between cathode and
> filament voltage wise on this tube. An arc from plate circuit to ground
> drives the negative side of the power supply high with respect to ground.
> This can allow the cathode to arc to the filament and ruin the tube.
> Floating the filament without the cathode tied to one side will help but you
> still run the risk of the filament transformer arcing and then having an arc
> to the cathode.
>
> If you do separate the cathode from the filament be sure that you have large
> protection diodes from the negative side of the HV supply to ground.
>
> 73
> Gary  K4FMX
>
>> -----Original Message-----
>> From: Amps [mailto:amps-bounces at contesting.com] On Behalf Of Roger D
>> Johnson
>> Sent: Saturday, October 05, 2019 8:54 AM
>> To: amps at contesting.com
>> Subject: Re: [Amps] Cathode Choke
>>
>> I may be wrong but the old memory banks came up with two possible
>> reasons
>> for the choke:
>>
>> 1. To prevent heater to cathode voltage breakdown
>>
>> 2. To prevent the heater to cathode capacitance from shunting drive
>> power to
>> ground.
>>
>> The first is probably not a factor in a low drive tube like the 8877.
>> The second
>> might only be at problem at VHF or above.
>>
>> 73, Roger
>>
>>
>> On 10/3/2019 3:47 PM, Roger Parsons via Amps wrote:
>>> I am attempting to repair a PT3000 amplifier for a friend. (This is a
>> prototype of a design that never went into production.) The amp uses an
>> 8877 in grounded grid.
>>> I am puzzled about the cathode choke, as the cathode and heater are
>> connected together for RF, all three connections go through the choke,
>> and the heater is fed from DC. This has the undesirable effect that
>> because of the voltage drop in the choke something over 6V is necessary
>> to give the proper heater voltage. And the DC supply has broken and I
>> want to replace it with a transformer....
>>> I can't see any advantage in doing things this way, but I may be
>> missing something. FWIW some other amps I have worked on have kept
>> heater and cathode separate and have worked fine (MLA2500 as original,
>> and as modified by me to use a 3CX800, an ex CBC 1kW FM broadcast
>> transmitter (8877), and as modified by me to be an HF Class AB1 amp.)
>> I'm sure that other examples can be found for both techniques.
>>> Is there a good reason?
>>> Thanks
>>> RogerVE3ZI
>>> _______________________________________________
>>> Amps mailing list
>>> Amps at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/amps
>>>
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps