[Amps] Fwd: B+W 850A parts?

[Carl]

I would suspect that fiberglass was added later. The two originals I have 
here are some form of plastic browning and cracking with age.

Carl


----- Original Message ----- 
From: "Robert" <woodr90 at gmail.com>
To: "Amps group" <amps at contesting.com>
Sent: Saturday, August 08, 2020 3:26 AM
Subject: [Amps] Fwd: B+W 850A parts?


> Similar issue, removed the old fiberglass type supports.   Used sheet of
> plastic about 3/16" thick and cut new somewhat square supports, could have
> been 1/4".
> The sheet is ldpe type plastic.   Found LPDE local - 1x1 foot piece and
> bought it.
> ebay should have something too
>
> https://www.dropbox.com/s/cnftynpvjquc9fu/2x400amp.jpg?dl=0
>
> link should show amp with good enough resolution to zoom into new supports
>
> .... Work in progress
>
> 73 W5AJ
>
>
> On Fri, Aug 7, 2020, 12:31 PM Mike Keller <w1bnc52 at gmail.com> wrote:
>
>> I was fortunate to save a Classy home brew 2 / 4-400 KW amplifier in a 
>> 4ft
>> rack from a trip to the landfill and am trying to bring it back to life.
>> The coil support rods in the B+W 850a are missing and I am looking for
>> suggestions for replacements.
>>
>> Mike Keller
>> W1BNC
>>
>> Typos bye iPhone
>>
>> _______________________________________________
>> Amps mailing list
>> Amps at contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps 


---
This email has been checked for viruses by AVG.
https://www.avg.com