[Amps] SB220 Meter blown...follow up hope
Jim
jimw7ry at gmail.com
Sat May 16 21:11:18 EDT 2020
Agreed Lou.
Thanks
73
Jim W7RY
On 5/16/2020 3:42 PM, gudguyham--- via Amps wrote:
> I measure meters with my digital ohm meter at least a few times a week and have been since I had high impedance ohm meters. Never blew up a meter yet. Of course you have to know how to do it.
>
> Sent from AOL Mobile Mail
> Get the new AOL app: mail.mobile.aol.com
> On Saturday, May 16, 2020, Jim Thomson <jim.thom at telus.net> wrote:
>
> Date: Fri, 15 May 2020 14:12:57 -0500
> From: Paul Kraemer <elespe at lisco.com>
> To: amps at contesting.com
> Subject: Re: [Amps] SB220 Meter blown...follow up hope
>
> <That will certainly test the meter movement!? It will pin hard once that
> <then you will know it is bad.
>
> <NEVER TEST A METER MOVEMENT WITH A OHMMETER!
>
> <Paul K0UYA
>
> ## Never had a problem so far..with my fluke 87 across meter movements..and they were 0- 1 ma types, if I remember correctly.
> I think this was with 87A manually switched to lower scales.
>
> ## I used to wire rvs connected diodes across both plate and also grid meter.
> These days I just wire the rvs diodes.. between B- and chassis. In some cases
> 2 diodes are used in series... 4 in total.
> In some cases, a resistor is wired in series with each rvs connected diode...that was a
> W6WRT trick..which works good.
>
> Jim VE7RF
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
More information about the Amps
mailing list