[Amps] AL811H and Chinese 811As

[gudguyham]

No problem just put them in.  There are mods suggested by W8JI the designer that can be fond on his website but it’s has nothing to do with the type of tibes.


Sent from the all new Aol app for iOS


On Thursday, January 7, 2021, 3:23 PM, Jay Sturtevant <k2ztdx at gmail.com> wrote:

Hello,

I recently purchased a set of finals from Ameritron/MFJ for my AL811H, but
have not installed them yet because I have "heard" and read the newer 811A
tubes do not have the same specs as the ones the AL811H was originally
designd around.  My amp was new in 2008 and the tubes I'll be replacing are
original.

I read that in 2011 the company did modify the original design. Now, I
believe, each of the grid resistors and  paralleled capacitors (RC) have
been removed from the circuit. The grids now go directly to ground. There
may have been other mods as well (??).

There are too many postings on the internet to draw a clear conclusion as
to whether or not I should make any modifications to my AL811H to
accommodate the new finals.  I was told by a tech at Ameritron, "no
modifications are necessary to accommodate new 811As, just check the 51 ohm
grid resistors". I like that!

I don't want to blow a new set! Thanks for your help!

Jay, K2ZT
_______________________________________________
Amps mailing list
Amps at contesting.com
http://lists.contesting.com/mailman/listinfo/amps