[Amps] 300Hz sidebands

Jim jimw7ry at gmail.com
Sun May 23 14:02:50 EDT 2021


Reported by whom?
What did they use to measure it?
Did you get a second opinion?
Is it your exciter?
Are you over driving your radio from the computer?




Since you run 1KW on FT8, have you been put on the "BUD" list and banned 
from FT8 for life?


Everyone knows that you can't run more than 1 microwatt on FT8....



Thanks
73
Jim W7RY

On 5/23/2021 11:35 AM, Conrad PA5Y wrote:
> Hi all.
>
> I have several tetrode amplifiers that run from a 3PH 50Hz supply. With the advent of the FT8 I have become aware that I have 300Hz sidebands at only -50dBc, this is obviously unacceptable. The supplies are from Rhode and Schwartz and are very well made and use an 8uF oil filled capacitor for smoothing. Some of the EU amateurs will know the supply, it is known as an IN 026 A1.
>
> I suspect that this problem has always been there.
>
> What is interesting is that Class AB1 or Class C, 100W out or 1kW out from the PA the sidebands are -50dBc. I did consider the G1 and G2 supplies but 300Hz suggests the 3PH supply and this happens with 3 different amplifiers, the only common factor is the HT supply. If it was ripple, I would have expected this to change depending on Anode current, but it doesn't. Unless of course the capacitor is completely shot. I will check that next, it's a little difficult to get to.
>
> The PSU details can be found here:
> https://www.dropbox.com/s/l71qj1g3qv7zh73/Servive%20Doc%20UHN284.pdf?dl=0
>
> Any ideas?
>
> Regards
>
> Conrad
>
>
>
> _______________________________________________
> Amps mailing list
> Amps at contesting.com
> http://lists.contesting.com/mailman/listinfo/amps



More information about the Amps mailing list