[Amps] Fw: help

[A Lawrence Fibich]

 Guess I am not sure how to post a listing -- thanks..
Larry FW6EF
   ----- Forwarded Message ----- From: A Lawrence Fibich <lfibich at sbcglobal.net>To: amps-request at contesting.com <amps-request at contesting.com>; amps-owner at contesting.com <amps-owner at contesting.com>Sent: Friday, October 21, 2022 at 11:32:03 PM PDTSubject: help
  Subject: Questions: Connecting a Drake Amplifier

 Hit a roadblock I am not understanding. I wanted to connect a Drake L-4 Amplifier (also have a Drake L-7 - same problem). Looking at the input the unit/s want - they want AGC input - I am familiar that ALL other Amplifiers I have used accept/require ALC input.  I am trying to drive either of these units with a ICOM IC -756 - it only outputs an ALC.  Of course the definitions of AGC and ALC is not the same - or about the same functions.
Then also - beyond my understanding clearly caution in the manual ... "WARNING: Set the Transceiver output power and linear amplifier ALC output level referring to the linear amplifier instruction manual.  The ALC input level must be in the range 0 V to -4V and the transceiver does not accept positive voltage.  Non-matching ALC and RF power settings could cause a fire or ruin the linear amplifier."QUESTION: 1. How do I connect the ICOM to the Drake Amp? - ? what if not connecting anything to the AGC on the Amp?2. How could a 'non-matching ALC and RF power setting cause a fire? ?over heating the Amp?
Thanks for any assistance73W6EFLarry FibichSacramento, CA area