[Antennaware] Antennaware Digest

[kg7hf at comcast.net]

I must be subscribed to the wrong list.   I didn't know this was only for antenna models, what a surprise, but then again, I've only been subscribed for about 2 years now, and seen maybe 10 messages go by the entire time. 



If it's for modeling, why not make a model then talk about it?    



How about this to get it started (and I am not so good of a model maker).   Basically, a 40m 4sq, sitting on the ground but using the ~70ft mast to hold it, they slope a littel inward.     I'm sure it could be tweaked to make it much better.   I can send the entire model if desired. 



Paul, kg7hf 





                   EZNEC Demo ver. 5.0 

Offset Fed Yagi -Uda for QEX                 2/18/2009     12:56:36 PM 

              --------------- WIRES --------------- 

No.          End 1   Coord. (ft)              End 2   Coord. (ft)       Dia (in)  Segs        Insulation 
      Conn.      X       Y       Z     Conn.      X       Y       Z                         Diel C  Thk(in) 
1       GND        0,      0,      0                0,      0,     70       #14   1           1        0 
2       GND       15,      0,      0              7.7,      0,     33       #14   5           1        0 
3       GND      -15,      0,      0             -7.7,      0,     33       #14   5           1        0 
4       GND        0,     15,      0                0,    7.7,     33       #14   5           1        0 
5       GND        0,    -15,      0                0,   -7.7,     33       #14   4           1        0 




Sources: 

Wire #   % from E1   Phase 

2                0                   0 

3                0                  -90 

4                0                  -90 

5                0                 180