LTA soundblaster software

aa2du at aa2du at
Thu Oct 13 03:09:50 EDT 1994

Hi Jim, I use a DVP and the output is instant. Sounds like Writelog may be creating
the delay.

73, J.P.
>Last night I was trying out the multimedia interface on WriteLog and found
>a second or so delay between hitting the function key and the output
>from the sound card. Does this delay occur in the LTA soundblaster software?
>Does this delay occur when using the CT DVP board? With the homebrew
>DVK, simular to the W9XT card, the output is NOW.
>Jim, 'Still working on the bad audio, just automating it', WA6SDM
>jholly at

J.P. Kleinhaus, AA2DU
ARRL Hudson Division C.A.C. Representative
E-mail:  aa2du at
             aa2du at
             kleinhaj at
Compu$erve:  74660,2606

TVI???  What TVI???

>From Peter G. Smith" <n4zr at  Thu Oct 13 11:51:02 1994
From: Peter G. Smith" <n4zr at (Peter G. Smith)
Date: Thu, 13 Oct 1994 03:51:02 -0700 (PDT)
Subject: Yaesu G-1000SDX Rotor Experience
Message-ID: <Pine.3.89.9410130349.A27401-0100000 at netcom3>

Has anyone out there had first-hand experience with the Yaesu G-1000SDX
rotor?  It is under $500 with a preset controller, rated for 23.5 square
feet.  Other specs, however (turning and braking torque, in particular),
more nearly resemble the 13 SF Create RC5, which is similarly priced. 
Other factors - it does fit inside Rohn 25, which I understand the Create
RC5A3 will not, and rotates over 450 degrees, which could be very helpful. 
finally, a friend reports that his G-1000SDX easily rotates a Tennadyne
11-element LP plus a 40-2CD, and that it both turned and braked that load
easily all through the last dreadful New England winter. 

Sounds too good to be true, since the Create costs $250 more.  Is it?

73, Pete                                       
N4ZR at
"Better, faster,cheaper -- choose any two"

More information about the CQ-Contest mailing list