Tailtwister and Rohn 25G

ehayes at VNET.IBM.COM ehayes at VNET.IBM.COM
Thu Dec 7 15:12:25 EST 1995

Thanks to all that responded on my friends question.  All said
a TT would fit in 45G but the responses were mixed on the 25G.
Apparently, the newest TT is not in the same configuration as the
older models which causes it not to fit thru the diagonals on a
tower section.  Several folks said if you have to cut, saw, etc.,
rethink how to assemble the thing.  Perhaps drop it down through
the opening at the top of the top section (the 2 ft. one).  Above all,
one should determine how he will remove the rotator when it eventually
fails before he finalizes the initial installation.

Again, thanks for the responses,

73  KC5DVT   Wayne     email...ehayes at vnet.ibm.com
Austin, Texas

More information about the CQ-Contest mailing list