[CQ-Contest] TS850S and CT9

[yo3ctk]

Hi Rick,

I went recently through the same process, and maybe I could offer some
insights:

1.	Before starting CT, run a COMTSR. If you are using COM1, for
instance, run COMTSR1. The parameters are as follows: -B4800 >-N82
Please notice the spaces.
2.	When you start CT, declare TS850 as RADIO1.
3.	In the configuration screen, declare RADIO1 on COM1 (or whatever
you are using) with 4800 bauds.
4.	Beware of IRQ conflicts. In my setup, I re-defined the IRQ table
so radio's COM does not share its IRQ with anything else.

After these steps, everything should be just fine. Please let me know if
I could be of further assistance.

73 de Mike, YO3CTK


	-----Original Message-----
	From:	Rick Dougherty NQ4I [SMTP:NQ4I at compuserve.com]
	Sent:	None
	To:	yo3ctk at ALLTROM.RO
	Subject:	[CQ-Contest] TS850S and CT9

	 Hi all...have spent a few hours this morning trying to get the
radio
	operating with ct9...Kenwood TS850S and the mfj interface...keep
getting
	the following message..."unable to initialize Kenwood radio














	--
	CQ-Contest on WWW:        http://www.contesting.com/_cq-contest/
	Administrative requests:  cq-contest-REQUEST at contesting.com


--
CQ-Contest on WWW:        http://www.contesting.com/_cq-contest/
Administrative requests:  cq-contest-REQUEST at contesting.com