[CQ-Contest] TS-950SD Rvcr Problems

[K4SB]

> I think this is just one of many 'board' problems that occur with Kenwood
> gear. I would open the thing up and check (ie. remove and replace) all the
> on-baord connectors. I have seen problems like this caused by the break-down
> of the potting compound used in the RF/PLL side too (albeit in a TS940).
> Stewart
> GM4AFF

I had this problem with a 930 also. Milt Lord ( The Radio Doctor )
repaired it by simply melting out the wax in the PLL can, and
resoldering the pins. Was was not replaced.

FWIW

73
Ed