[CQ-Contest] Swing arm assembly???????

Bill Tippett btippett at alum.mit.edu
Wed Feb 10 16:43:55 PST 2010


 > Try this 
After a
little thought I reverse-engineered the design and had a neighbor who
does race-car fabrication make one up for me - much cheaper.  He used a
piece of a plastic cutting board for the top bearing - still going
strong after 6-7 years.

         Mine have no bearing at the top...just a sleeve which the top of
the rotating mast fits into.  It's not that critical just so you don't
have a huge amount of play at the top.  These have been up 10 years
with no problems:


                                         73,  Bill  W4ZV

More information about the CQ-Contest mailing list