[CQ-Contest] Info request

[Tod]

This may be off topic since it does not deal with contest rules, cheating
and the like.

 

I am trying to install a RotorCard DXA on a G2800DXA. The general
instructions for the physical install seem easy enough but adjusting the
system and testing the system once the card is installed is said to be done
with Hyper Terminal or a similar program. Has anyone successfully installed
such a card ? If so, can you share with me what the commands are that one
uses to communicate with the rotator to enable adjustment of the on board
pots so that the orientation and end points are correct.

 

Thanks for any help including just a reference leading to finding the
information on the internet somewhere.

 

Tod, K0TO