[CQ-Contest] RECORDING ON FT5000 FT2000 FT950

[Andy Melanin]

In my FT5000 everything works ok. The only problem is the signal level is too low, so I have to use  the additional 10dB audio amplifier to have good signal for the recording. Yaesu must do regulated output like in Elecraft K-3

73! Andy UA3DPX

Отправлено с iPad

> 5 марта 2017 г., в 7:01, Trent Sampson <vk4ts at outlook.com> написал(а):
> 
> All this recording talk has made me revisit the shack configuration.
> 
> 
> After testing the FT2000 FT950 I can get the RX audio out of the RECORD Jack on the rear panel but no transmit audio on any modes
> 
> 
> The Manual(s) says to set monitor to on - but there is no difference -
> 
> 
> Modes will be SSB RTTY and CW.
> 
> 
> Has anyone successfully done this or do I need to try some other point?
> 
> 
> My issue is the FT5000 rigs are at a remote site and really want to be able to sort this out prior to the 4 hour round trip to the remote.
> 
> 
> Thanks in advance.
> 
> 
> Regards
> 
> Trent
> VK4TS
> PO Box 275
> Mooloolaba 4557
> 0408497550
> 
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest at contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest