[CQ-Contest] Off Topic - Rig blaster and WSJT-X

Jeff Clarke ku8e at ku8e.com
Sat Dec 21 21:52:52 EST 2019


Carol,

I use a Rigblaster Advantage with my K3. Here are my settings in WJST-X:

CAT Control :

Serial Port COM4

Baud Rate 38400

Data Bits 8

Stop Bits 1

Handshake  NONE

PTT Method RTS

Transmit Audio Source  Front Mic

Mode USB

Split Operation NONE

The mic cable from the Rigblaster is plugged into to MIC connector in 
front of the radio . Have you checked to see if your speaker/mic is 
using the input/outputs from the Rigblaster and not your computer 
speaker/mic? Also check to make sure the volume for the Rigblaster isn't 
muted. My master volume is about half way up. Are you seeing any green 
on the left bottom side of the WJST-X program? If not you aren't getting 
any audio from your radio.

Hope this helps.

Jeff


On 12/21/2019 03:57 PM, Carol Richards wrote:
> Hello all,
>
>
> I am using a Rig Blaster advantage with WSJT-X. It was working fine 
> until I made some mods in the shack. Now it doesn't decode anything. 
> Is anyone out there using a rig blaster advantage with WSJT-X and can 
> help me trouble shoot my problem? I know my settings are good in the 
> program so it must be a cable problem. I did run a time sync program 
> to no avail.
>
>
> Thanks,
>
>
> Carol
>
>
> _______________________________________________
> CQ-Contest mailing list
> CQ-Contest at contesting.com
> http://lists.contesting.com/mailman/listinfo/cq-contest
>


More information about the CQ-Contest mailing list