yaesu g-xxxx rotor control

[David Robbins]

for abt $150 plus a few misc parts i have made a programmable controller 
for the yaesu g-xxxx rotor series. (yaesu's board lists for abt $350).  
what i don't know is what are the commands that get sent from the 
computer to the rotor?  anyone have the protocol??  this controller not 
only talks rs-232, but could have probably 16-20 preset's (if you wanted 
that many switches).  I also think that with the addition of a couple 
small relays it could control just about any rotor the same way.  anyone 
interested in such a beast??? 

73, dave
-- 
ky1h@berkshire.net   or   robbins@berkshire.net
http://www.berkshire.net/~robbins/ky1h.html


--
Submissions:              ct-user@ve7tcp.ampr.org
Administrative requests:  ct-user-REQUEST@ve7tcp.ampr.org
WWW:                      http://www.ve7tcp.ampr.org/Software/ct
Questions:                owner-ct-user@ve7tcp.ampr.org