[ct-user] Strange thing happening on a hub

[Eawalter at aol.com]

Dave
What operating system are you using?
Is it the same on all of your computers?
 
Different MicroSoft  versions have some network limitations.
 
73
Gene
W2CP
 
 
 
------------------------------------------------------------------------------
-----------------
 
In a message dated 8/30/2007 11:10:34 A.M. Eastern Daylight Time,  
dave at ka1n.cn writes:

This  might be a hardware problem, but maybe someone here has seen it has a 
software  problem.  I am running (or trying to run) NETTSR on five TP 770s, 
with  3C589D PCMCIA cards.  I can get two computers to talk to each other via a  
cross-over cable.  But, when I plug them into a hub with a patch cable, I  get 
results like this:

Computer one can broadcast and receive from all  computers.
Computer two can only communicate with computer one.
Computer  three can communicate with computer one
Computer four can communicate with  computer one
etc.

All the computers have different "IP  addresses."  I am using the EN106TP 
hub.  I have tried hooking up  one computer via a cross-over cable to the hub, 
and switching one port to  “uplink” (same result.)  

Any ideas (besides simply getting  another hub)?

Thanks,
73,  
Dave/KA1NCN
Dave at KA1N.CN
.


_______________________________________________
CT-User  mailing  list
CT-User at contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT  on the web:  http://www.k1ea.com/







************************************** Get a sneak peek of the all-new AOL at 
http://discover.aol.com/memed/aolcom30tour