[na-user] Radio control

[jcullum]

Run the config.exe program and there is a section in there to tell the
program what hardware you have.  There is only one choice for Kenwood radios
("Kenwood"). So just choose that and you are off and running. 

When you run NA there will be a hardware box that comes up that asks you
what hardware you want enabled.  Just make sure there is a "X" in the "radio
1" box (assuming that you set the 940 as radio 1 in config.exe).  

If you have the 940 working with CT, you should not have a problem with NA.

Good luck.

Jim/K7MK

-----Original Message-----
From: Gilmer, Mike [mailto:mgilmer@gnlp.com]
Sent: Wednesday, May 19, 1999 12:38 PM
To: 'NA-USER'
Subject: [na-user] Radio control



Fellow NA'ers -

I'm a new owner of NA - just bought (had emailed to me from Radio Book
Store) 10.38.
Since I won't see a manual for a few days - got a question:
How does one choose the type of radio (e.g., TS-940) ?
I have found no obvious mention (other than a .lst file with some
models) in the help.
Any other related info (for radio control) that I need?
I currently use CT with the TS-940.  So have cable, etc.

Thanks,
Mike N2MG
mgilmer@gnlp.com

--
Submissions:              na-user@contesting.com
Administrative requests:  na-user-REQUEST@contesting.com
WWW:                      http://www.contesting.com/datom/
Questions:                owner-na-user@contesting.com

--
Submissions:              na-user@contesting.com
Administrative requests:  na-user-REQUEST@contesting.com
WWW:                      http://www.contesting.com/datom/
Questions:                owner-na-user@contesting.com