[NA-User] ICOM 738

[David Pruett]

After reading Tim's note, I realized that I had the connector 
descriptions reversed in my previous e-mail.  I was describing the 
mating connectors but referring to them being on the computer itself.

Tim is correct.  COM ports have male connectors on the computer.  LPTs 
have female.

Dave/K8CC

k9tm at buckeye-express.com wrote:
> On the computer side of things, is the 25 pin connector a male or female?  If it is a male, then it is likely a COM port.  If it is a female, then it is likely a LPT port.  In config, does NA show that it recognizes 2 COM ports?
>
> 73, Tim K9TM
> --- jdrog at bellsouth.net wrote:
>
> From: James Rogers <jdrog at bellsouth.net>
> To: na-user at contesting.com
> Subject: [NA-User] ICOM 738
> Date: Thu, 21 Jan 2010 12:45:41 -0500
>
> Folks,
>
> I have an ICOM 738 that I can not seem to get talking to NA.  CW is  
> working fine from Com port 1.
>
> My CT-17 Icom interface goes to a 25pin connector on the computer. Is  
> this Com port 2 or an LPT port?
>
> Any help would be appreciated.
>
> Jim N4du
> _______________________________________________
> NA-User mailing list
> NA-User at contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
> NA on the web:  http://www.datomonline.com/
>
>
> _______________________________________________
> NA-User mailing list
> NA-User at contesting.com
> http://lists.contesting.com/mailman/listinfo/na-user
> NA on the web:  http://www.datomonline.com/
>
>