[NCC] [MRRC] Headphone questions

[Barney Scholl]

There is also at least one add-in boom mike available. Pricey but integrated. Uflymike 

Barney K3LA

> On Aug 28, 2018, at 11:33 AM, Jim K8MR via NCC <ncc at contesting.com> wrote:
> 
> 
> I recentlty inherited two Bose QC15 headphones from my daughter (heaven forbid one uses headphones with cords!) which are wonderful phones. They also worked in the car this past weekend with no problems - something the old Heil Proset did not like, with all the RF floating around (loud clunks listening to my own signal). 
> 
> 
> 
> Microphones are an issue. I had an old Heil mike on a metal boom from one of their earliest headsets (ones that just sat on the ear, but did not cover it). I kluged together a mount which sort of held it in place, but I found I had to push it the last inch to get it close enough to my lips for full modulation.
> 
> 
> K8AZ uses Bose headsets, having used epoxy to attach a similar small boom mike to the left ear.
> 
> 
> 
> 
> 73   -  Jim
> 
> 
> 
> 
> 
> 
> -----Original Message-----
> From: K9TM <k9tm at buckeye-express.com>
> To: Robert Hayes <kw8n at aol.com>
> Cc: ncc <ncc at contesting.com>; mrrc <mrrc at contesting.com>
> Sent: Tue, Aug 28, 2018 7:29 am
> Subject: Re: [MRRC] Headphone questions
> 
> 
> 
> Heil products are infamous for wiring issues.
> Heil is very good about either fixing things (you send the parts to them) or sending you the parts if you contact them.
> 73, Tim K9TM
> 
> 
> On 2018-08-27 21:21, Robert Hayes via MRRC wrote:
> First question:
> I have been using a Heil Pro 7 set of headphones for the past few years.
> I like the ambient noise reduction compared to other Heil Pro type headphones from the past, especially when using amplifiers with noisy fans.  The issue I had over the OHQP weekend was wires breaking in the cable where it attaches to the headphones, right in the connector that is referred to as a 6 pin mini XLR.  (I probably tugged on it too many times.) Fixed the right ear (red wire)  Friday night.  But never checked the microphone portion again until the OHQP had already started.  Started on CW but later when went to phone had no mic function.  The white wire was broken, so found an old pair of headphones only and operated CW with those while fixing the Pro 7 mic wire.  (Never did put the shell back on the cable end, in the interest of time just taped it to microphone boom as a "strain relief".)
> 
> I can put it all back together, but would feel more comfortable with a new cable assembly.  Having a hard time finding that as a replacement part.
> "Military spec cable system using 6-pin mini XLR and fiber reinforced cable"  the other end is two miniature phone plugs, one for mic and one for headphones.
> 
> 
> Second question:
> What is your opinion as to headphones with boom mics.  Inrad has a new one?  Has anyone tried that one?  Any that you like better than Pro 7?
> 
> 73 TNX Bob KW8N
> 
> 
> _______________________________________________
> MRRC mailing list
> MRRC at contesting.com
> http://lists.contesting.com/mailman/listinfo/mrrc
> 
> _______________________________________________
> MRRC mailing list
> MRRC at contesting.com
> http://lists.contesting.com/mailman/listinfo/mrrc
> 
> _______________________________________________
> NCC mailing list
> NCC at contesting.com
> http://lists.contesting.com/mailman/listinfo/ncc
>