[Orion] Orion I firmware

[Martin, AA6E]

The solution, sadly, is to reload v 1.372.  That's what many of us
have done.  This beta version is way too much "beta".  Sad, because it
shows a lot of promise.

AN worked OK for me, but the SP situation was unacceptable.

Would anyone like to start a pool and take a bet on when the next
non-beta Orion 1 version comes out?  Probably not soon, or they would
not have released 2.054b.

73 Martin AA6E

On 2/19/06, Andy Hamon <andyh at cwgsy.net> wrote:
> Guys
>
> Loaded the new v2 firmware onto my Orion yesterday afternoon and
> tried it in the ARRL test.
> The "upload" went fine and after doing the Master Reset and
> reconfiguring my parameters, everything is great EXCEPT one thing.
>
> When I switch in the auto notch, the audio goes from being crystal
> clear to unreadable! At setting 1, the signal is just readable, only
> just. At setting 9, forget it. The radio sounds like a real cheap AM
> BC receiver being overloaded. The distortion is awful.
>
> Same result in SSB as CW.
>
> Under firmware v1, no such problem.
>
> Is it worth reloading the firmware?
> Is it a setting a bit further up the chain that is overdriving
> something when the auto notch?
> Is it a user problem?
>
> Any suggestions??
>
> Thanks & 73
>
> Andy, GU4WTN
> _______________________________________________
> Orion mailing list
> Orion at contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>


--
martin.ewing at gmail.com
http://blog.aa6e.net