[Orion] Orion display issue

Duane A Calvin ac5aa at juno.com
Fri Mar 31 15:35:27 EST 2006


Joe,
        It's a common trait with the new 2.x FW that the contrast
settings have changed significantly.  I set mine for "white on black" and
find also that 36-40% is what I find best looking.  I have not
experienced the problem with selecting the options that you mentioned. 
It was difficult to see the options when I first load a FW level because
the contrast setting is not one that is retained, and the default is
inadequate for good viewing.  Hope this helps.

        73,  Duane


On Fri, 31 Mar 2006 15:31:45 -0500 Joe Giacobello <k2xx at swva.net> writes:
> I am using firmware version 2.05 and it has been a major improvement 
> 
> over v. 1.372.  However, I recently turned off my gear and when I 
> turned 
> it back on again, the display was much dimmer and I was not able to 
> 
> select the various options in the menus because the highlight would 
> not 
> move from its topmost position.  The highlighted selections tended 
> to 
> "stretch" as I turned the main dial but would  not move to the next 
> 
> selection.
> 
> Finally, I did a master reset and after persisting at the menus for 
> a 
> while, I was able to select the display contrast.  Now, in order to 
> have 
> an acceptable display, I had to reduce the contrast to 36%.  
> Originally, 
> it was at 50%.  The highlight selections are still are little 
> erratic.
>  
> I wonder if anyone else has had this problem and if they know the 
> cure.
> 
> 73, Joe
> K2XX
> _______________________________________________
> Orion mailing list
> Orion at contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
> 
> 


Duane Calvin, AC5AA
Austin, Texas


More information about the Orion mailing list