[RFI] Ferrite Beads
Jim Brown
jim at audiosystemsgroup.com
Tue Oct 19 01:32:03 EDT 2004
On Mon, 18 Oct 2004 20:57:54 -0500, Ford Peterson wrote:
>Since there is no connector set available from Toyota, I'm stuck either slashing the
>harness and inserting a toroid with 4 conductors and cobble together some kludge
>job that would void t
There are other options. Look at the Fair Rite catalog (study it carefully -- it takes hours to
digest this stuff, and more hours to select the right parts). There are some VERY large
clamp-ons of #31 or 78 material (don't remember which) that you could potentially get
several turns through. Study the dimensions of the clamp-ons, the dimensions of the wires,
order a selection of them, and give it a shot. You are looking for a ferrite part that is as
long as possible (consistent with the available length of wire). R and X are proportional to
length and proportional to the SQUARE of the turns. So two turns through a shorter core is
twice as good as one pass through a longer one. AND the greater number of turns will
move the effective range down in frequency.
Jim Brown K9YC
More information about the RFI
mailing list