[RFI] Low pass filter opinions

[Jim Brown]

On 1/13/2011 3:08 PM, dalej wrote:
> Would it be best for me to run a separate wire from each XLR pin 1 to the nearest point on the chassis, which might require drilling holes?  Or perhaps one hole drilled in the chassis at the opposite end of the PCB with another wire to a stud there.  I'm not planning to sell this as it has no second hand value so drilling holes is not a big deal as long as it's not in the front panel.

NO!  Go back and study what I've written in earlier posts over the last 
few days.

73, Jim K9YC