[RFI] RFI Question
dave at nk7z.net
Sun Jun 24 20:32:34 PDT 2012
I have a question for all you RFI folks... I found a Cable Line Amp
which is putting out Ultrasonic sounds, but no detectable RF on 125
MHz... Is this normal? It is a trunk amp hanging from the cable trunk.
It is about two blocks from my home, so I do not think that is the issue
Also my 20 over S9 noise is back, I hear nothing from a suspect pole
using Ultrasonic, but I get a very deep null using the MFJ antenna
directly pointing to the pole, and the meter is reading 80 out of 100,
when not nulled. I also get the picket fence as I drive the power line
leaving the pole in both directions, and it gets lower in level on 125
MHz. as I depart the pole area. I accidentally leaned, (actually I
tripped and fell into the pole), on the pole while listening to the
noise on 125 MHz, and it changed for the worse, as I hit the pole. I
don't want to start pounding the pole, so I will be calling the power
company again tomorrow morning.
Any other suggestions as too how to further rule out the offending pole?
I am trying to prove it is NOT this pole, prior to calling the power
http://www.nk7z.net for equipment reviews, propagation, and more...
I can melt ice with my mind... Takes a few minutes though...
More information about the RFI