[RFI] Ferrite core and hot glue?
Larry Benko
xxw0qe at comcast.net
Fri Aug 23 09:52:27 EDT 2019
Martin,
About the only way to damage a ferrite core is to heat it above the
curie point or to crack it by dropping it or contacting it with a hard
object. 61 material ferrite has a Curie temperature in excess of 300
deg. C. I have measured cores that were held to a PCB via nothing, hot
glue, silicone, epoxy, and double sided tape and couldn't measure any
difference. However if you use so much adhesive that it get up on the
turns the performance can change since there will be some increase in
the winding capacitance.
Larry, W0QE
On 8/23/2019 3:22 AM, Martin Kratoska wrote:
> I need to fix a choke balun wound on a BN61-2402 binocular core to the
> PC board. The hot glue has 200 degs C when applied. Can it destroy the
> core?
>
> 73,
> Martin, OK1RR
> _______________________________________________
> RFI mailing list
> RFI at contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
More information about the RFI
mailing list