[RFI] Common mode choke on 4 Square feedlines without skewing phasing?
N2TK, Tony
tony.kaz at verizon.net
Tue Feb 19 08:35:48 EST 2019
Jim,
Thanks for all of your help with this. You have significantly increased my confidence that I will be setting up the feedlines correctly for my 80M 4-sq.
After I do this I need to wind 6 chokes for my 75 ohm fed receive antennas.
Tnx agn
N2TK, Tony
-----Original Message-----
From: RFI <rfi-bounces at contesting.com> On Behalf Of Jim Brown
Sent: Monday, February 18, 2019 7:14 PM
To: rfi at contesting.com
Cc: Ward Silver <hwardsil at gmail.com>
Subject: Re: [RFI] Common mode choke on 4 Square feedlines without skewing phasing?
Tony,
Here are my recommendations for 75 ohm transmitting chokes wound with FEP or PTFE mini-coax RG179 on 2.4-in o.d. #31 toroids. Turns are wound close-spaced (touching on the inside diameter). As previously noted, this coax has fairly high loss, so the choke should not see more than the approximately 360W it would see when divided equally between four verticals, and even at that power level, it MUST be exposed to air. Note that I am NOT saying that they CAN handle this much power -- that's up to others to verify.
160M: 27 turns 12K Ohms Rs
80M: 24 turns 13.5K Ohms Rs
40M: 22 turns 10K Ohms Rs
To develop these recommendations, I wound Grant's coax on the same four cores at the limits of recently purchased cores used for my recent RG400, THHN, and Teflon pair 2018 Cookbook, tabulated the data, and chose worst case (lowest) values for Rs on each band.
73, Jim K9YC
On 2/18/2019 1:15 PM, Jim Brown wrote:
> On 2/18/2019 11:40 AM, tony.kaz at verizon.net wrote:
>> Thanks for the input. I use dumped power to check the bandwidth.
>> Okay, will
>> use RG400 for the chokes.
>
> That's 50 ohm coax, so not ideal for your application. KZ1W sent me
> some miniature TFE coax to measure, the size of RG179, which is 75
> ohms with FEP jacket. That would be a better choice. Because it's so
> small (0.1-in o.d.), dissipation is fairly high, so it will be
> important that it be exposed to air. I'm currently developing winding
> guidelines for it. Because it's so much smaller than RG400, they are
> very different.
_______________________________________________
RFI mailing list
RFI at contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
More information about the RFI
mailing list