[RTTY] determining shift/baud

[Bill Turini]

Folks

I know this question might be alien to most of the list who use
computers to run rtty,  :-) but perhaps there's a few old-timers out
there...

How does one determine the baud rate/shift for a signal with a hardware
decoder such as a Dovetron? 

I like to monitor various signal on the bands, but have yet found a
discussion on how to set the controls to tune in a signal. There's a lot
of information on computerized rtty, but some of us like to run the
older stuff. Any comments or pointers to instructions would be
appreciated. 

Thanks for the bandwidth.

Bill  KA4GAV

Bill Turini                         (425) 787-4477
IT & Facilities Manager
Cypress Semiconductor               Lynnwood, WA  98037