[RTTY] need help interfacing TS850 to Hal DXP38

[kevin at kd1j.com]

  I noticed that the www.buxcomm.com website has available a
ready-made (one-end) 13 pin DIN cable to make things a little
easier...

73,
Kevin

  <><><><><><><><><><><><><><>
  Amateur Radio Station - KD1J
  Kevin D. Jacobson
  27 Ridge Road
  Wallingford,    CT.    06492
  e-Mail:       kevin at kd1j.com
  Website: http://www.kd1j.com
  <><><><><><><><><><><><><><>



On Thu, 11 Mar 2004 22:58:13 -0700, "David Hachadorian" wrote:

> 
> 
> ----- Original Message ----- 
> From: "David Ashworth" <fathom at Access4Less.net>
> To: <RTTY at contesting.com>
> Sent: Thursday, March 11, 2004 9:27 PM
> Subject: [RTTY] need help interfacing TS850 to Hal DXP38
> 
> 
> > Hello, decided to go with a HAL.  Been looking over the manuals for each
> > piece of equipment and not quite clear on the hookup.  This is what I
have
> > come up with: FSK jack on Hal to RTTY jack on TS850 with RCA plugs,  AF
> OUT
> > jack on HAL to TS850 ACC2 pin 3 ,  AF IN jack on HAL to TS850 ACC2 pin
11.
> > The Hal also has a PTT jack, would that go to pin 9 on ACC2?  Thanks in
> > advance for your help, Dave, NC6P.
> >
> 
> I hate that 13 pin din on the 850.
> The male connector is hard to find, the pins are
> close together, and it is susceptible to
> rfi.
> 
> I take the audio off the speaker output. Yes,
> you have to pay attention to the af gain control.
> If you are using FSK, you don't need audio in
> (unless you are doing psk31 or some foolishness
> like that).
> If you need a ptt, You can use the mic connector
> on the front panel. It works in all modes. Some
> software control programs can do a software
> ptt over the radio control line.
> 
> Dave Hachadorian, K6LL
> Yuma, AZ
> 
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty