[RTTY] Mark & Space - High Tones

[Jim W7RY]

Yup! There you go Joe.

73
Jim W7RY


--------------------------------------------------
From: "Joe Subich, W4TV" <lists at subich.com>
Sent: Wednesday, June 08, 2011 8:31 PM
To: "Jim W7RY" <w7ry at inbox.com>
Cc: "Phil Sussman" <psussman at pactor.com>; "RTTY" <rtty at contesting.com>
Subject: Re: [RTTY] Mark & Space - High Tones

>
> Actually "low tones" were 1275/1445 ... more common in Europe than
> in the US.  915/1085 (centered on 1000 Hz) is another artifact of
> modern programmers who did not understand RTTY and were used to
> 1 KHz as a "benchmark" in PSK31.
>
> 73,
>
>    ... Joe, W4TV
>
>
>
> On 6/8/2011 8:59 PM, Jim W7RY wrote:
>> The use of the name "high tones" refered to 2125/2295.  Low tones were
>> around 900/1070 (give or take).
>>
>> Hal communications manufactured ST-6000s with either set of tones.
>>
>>
>> Please don't confuse high/low tones with which one is mark or space. It's
>> either mark or space. Not high or low tone.
>>
>> 73
>> Jim W7RY
>>
>> --------------------------------------------------
>> From: "Joe Subich, W4TV"<lists at subich.com>
>> Sent: Wednesday, June 08, 2011 12:22 PM
>> To: "Phil Sussman"<psussman at pactor.com>; "RTTY"<rtty at contesting.com>
>> Subject: Re: [RTTY] Mark&  Space - High Tones
>>
>>>
>>>> On USB I believe the designations should be reversed, since 2125 Hz
>>>> would be the LOWER RF frequency.
>>>
>>> You are correct.  MARK is the tone that provides the *HIGHER* RF
>>> frequency.  Thus if you use USB AFSK the conventional "High tones"
>>> would be 2295 Hz = Mark and 2125 = Space.
>>>
>>> Nearly all material on RTTY (and most Yaesu transceivers designed prior
>>> to the FT-9000/FT-2000/FT-950) assumes operation in LSB as that was the
>>> "standard" for nearly 30 years until the "lazy programmers" showed up
>>> with multi-mode software like HRD, fldigi, MixW, etc. that only worked
>>> in USB.
>>>
>>> Unlike software from the "lazy programmers," MMVARI allows selecting
>>> *either* USB or LSB for sideband sensitive modes like RTTY, MFSK, and
>>> QPSK.
>>>
>>> 73,
>>>
>>>     ... Joe, W4TV
>>>
>>>
>>> On 6/8/2011 12:58 PM, Phil Sussman wrote:
>>>> I've been wandering on the AA5AU RTTY pages in search of
>>>> Don's email address.
>>>>
>>>> After my exchange with Chen, I had a question about the
>>>> RTTY Intro page on Don's site. It is noted that high tones
>>>> are 2125Hz and 2295Hz (170 Hz split), Mark and Space
>>>> respectively. While nothing is specifically mentioned at
>>>> that point, the Mark and Space designations given are only
>>>> applicable for LSB. On USB I believe the designations should
>>>> be reversed, since 2125 Hz would be the LOWER RF frequency.
>>>>
>>>> Am I right or merely confused?
>>>>
>>>> Thanks ES 73,
>>>>
>>>> de Phil - N8PS
>>>>
>>>>
>>>>
>>>>
>>>> _______________________________________________
>>>> RTTY mailing list
>>>> RTTY at contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/rtty
>>>>
>>> _______________________________________________
>>> RTTY mailing list
>>> RTTY at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/rtty
>>>
>>>
>>>
>>> -----
>>> No virus found in this message.
>>> Checked by AVG - www.avg.com
>>> Version: 10.0.1382 / Virus Database: 1511/3687 - Release Date: 06/07/11
>>>
>> _______________________________________________
>> RTTY mailing list
>> RTTY at contesting.com
>> http://lists.contesting.com/mailman/listinfo/rtty
>>
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1382 / Virus Database: 1513/3689 - Release Date: 06/08/11
>