[RTTY] Hal st-8000 help

[Jay WS7I]

See the main page at http://www.ewarg.org  for Chen's Regen stuff on the 
ST-8000.

Also the front panel switch under Regen would be set B/B for 
Baudot/Baudot.  Make sure the Input Mark/Space/Baud equals the output.  
The switch marked input/output
shows you what they are.

Good luck.

On 10/26/2014 8:08 AM, Tom Guntzel wrote:
> I have just acquired a st8000 and want to use the regen feature.  It is my understanding that the st 8000 will output a clean audio signal that can then be feed into a sound card program or other hardware that takes an audio input.  I can't tell from the manual where to get this filtered output.
>
> Can anyone help,  may have to adjust a couple of dip switches as well.
>
> Help appreciated
>
> Tnx
> Tom G
> K0TLG
>