[RTTY] GRITTY in N1MM+

[Kermit (aka Ken) via RTTY]

Thanks to everyone who responded to my question. The problem is  solved.  I 
needed to resize my receive startup menu window because the  GRITTY path 
fell off the bottom.  As simple as that.  Make sure your  window is tall 
enough, select GRITTY, enter the path at the bottom and away you  go.  For use 
follow the instructions below.  
 
It works.
 
TU & 73,
Ken, AB1J
 
 
In a message dated 2015-04-29 8:52:36 P.M. Coordinated Universal Tim,  
ve3iay at storm.ca writes:

Ken,

In the RX window setup, you have to first select the  GRITTY window type 
at the top. That should enable the GRITTY Setup path  box at the bottom 
of the window. After selecting the path, click on Save.  The RX window 
should close and re-open - if it doesn't, close it and  re-open it manually.

DO NOT put the path to Gritty in the MMTTY setup  the way you do with 
2Tone. 2Tone is written as a direct plug-in  replacement for MMTTY and 
uses the same interface with the main program,  so you can use it as a 
direct substitute for MMTTY, but Gritty uses a  completely different 
interface method and cannot be invoked the same way  as MMTTY.

When you are using Gritty, you do not click in the additional  RX window 
the way you do with the other digital engines. Instead, you have  to 
click on call signs in the Gritty window. I'm not sure whether clicking  
on exchanges works yet - the only things I've been able to click on  
successfully are call signs.

I will be documenting Gritty in the  N1MM Logger+ manual once I get it 
working properly here - I've been having  various teething problems with it.

73,
Rich  VE3KI