[RTTY] N1MM Exch Message when using ESM?

[RLVZ at aol.com]

Hi Guys,
 
I was going to post my question on the N1MM logger+ Digital reflector,  but 
since Don brought up a related subject, and since rtty at contesting  .com is 
easier for me to post messages on, I'd like to ask the following  question 
about N1MM Logger+:
 
For this weekends NAQP-RTTY Test, I was using N1MM Logger+ V.1.0.5785.0  
(which I believe is the latest version) and using ESM.  ESM worked  flawlessly 
when running stations.  But while hunting MULTS in  S&P mode I frequently 
had problems.  After entering the other stations  Callsign in the Callsign 
field and pressing "Enter" the first time, ESM would  always send my Callsign 
just as it should.   But after filling the logging fields with the proper 
received message  and then pressing "Enter" the second time in order to send 
my  exchange and automatically log the Qso, about 30% of the time  Logger+ 
sent my Callsign again rather than sending my report and logging  the Q.  That 
really messed me up and may have cost  me logging some Q's because of it.  
So I'm wondering if  anyone else experienced a  similar problem?     
 
Thanks & 73,
Dick- K9OM   
 
 
 
In a message dated 7/17/2016 11:16:18 A.M. Central Daylight Time,  
rtty-request at contesting.com writes:

Message:  1
Date: Sat, 16 Jul 2016 17:58:33 -0500
From: "Don Hill AA5AU"  <aa5au at bellsouth.net>
To: "'RTTY Reflector'"  <rtty at contesting.com>
Subject: [RTTY] N1MM Exch Message when using  ESM?
Message-ID:  <000d01d1dfb5$950bfb00$bf23f100$@net>
Content-Type: text/plain;   charset="us-ascii"

OK, I give up. How do your properly set up  your F2 (EXCH) RUN message when
using ESM?

I want to send the other  station's callsign ONCE with my report starting on
a new  line.

Thanks,
Don  AA5AU