[RTTY] Intel NUC, anyone?

[Jim W7RY]

I have also found the Edgeport USB to serial boxes work fine.

73
Jim W7RY


-----Original Message----- 
From: Joe Subich, W4TV
Sent: Friday, October 27, 2017 10:06 AM
To: rtty at contesting.com
Subject: Re: [RTTY] Intel NUC, anyone?


Edgeport is the only maker of USB to Serial converters that I know of
that properly support low (45, 50 and 75 baud) data rates.  Again, their
converters are microprocessor based with a hardware bit clock.  It is
not necessary to use EXTFSK or other software FSK "drivers" with the
Edgeport products.

73,

    ... Joe, W4TV


On 10/27/2017 10:42 AM, Jim McDonald wrote:
> Would an Edgeport USB-to-serial adaptor work?
>
> 73,  Jim N7US
>
> -----Original Message-----
>
> Hi Peter,
>
> Have you looked into TinyFSK?
>
> http://www.frontiernet.net/~aflowers/tinyfsk/
>
> I was looking into doing something similar as you with either a small form
> factor PC, cheap laptop or some other device (which I still have to get).
> Realizing that they would not have a serial port for FSK keying, I built 
> an
> interface that included the TinyFSK. It worked very well for me. I used it
> with the N1MM logging software for some contesting as well.
>
> 73,
> --Alex KR1ST
>
>
> On 2017-10-25 22:31, Peter Laws wrote:
>
>> Now my problem is that the NUC has no serial ports.
>
>
> _______________________________________________
> RTTY mailing list
> RTTY at contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
>
_______________________________________________
RTTY mailing list
RTTY at contesting.com
http://lists.contesting.com/mailman/listinfo/rtty