[SCCC] Mark V field won't transmit or gets locked

[w6now]

Thanks to all who sent me suggestions.

So far I'm lucky. I ran the rig yesterday during NAQP, with Microham, and few other things and it did not suffer from any problems. I also think there was a setting on the Microham that was causing the rig to be placed into Tx mode by the PC.

It all seems good now, I'm happy again.


On Jan 15, 2010, at 1:01 PM, Wild Bill Wiederhold wrote:

> A good source of info can be found at this site: http://www.va3cr.net/ 
>  
> de WB
> 
> On Thu, Jan 14, 2010 at 5:15 PM, w6now <w6now at ham.jdlabs.net> wrote:
> > [SUB(CE)] + [29(0)] + [ENT] + POWER on: CPU master reset for all
> > memories and menu setting.
> >
> Good suggestion.
> 
> After I sent my email, i went back and looked at the ground connections. I replaced the one for the rig (which was 14AWG) vs 12AWG for the rest of the connections (not sure if there is a scientific explanation for this), but now the rig has been running for 30 minutes without locking (it normally took about 15-20 minutes for it to lock itself).
> 
> w6now.
> _______________________________________________
> SCCC mailing list
> SCCC at contesting.com
> http://lists.contesting.com/mailman/listinfo/sccc
> 
> 
> 
> -- 
> Mele Kalikimaka me ka Hau'oli Makahiki Hou,
> 
> Wild Bill
> 
> Go confidently in the direction of your dreams!
>