[SCCC] N1MM

[Dennis Younker NE6I]

Thanks Dave, I do not have RS-232 to the radio. I'm using the serial port to 
key the radio, but not to interface otherwise. I'm running an old TS-940S, 
so without the IFC-232 or whatever it was, there is no way to interface.

Are you saying that I didn't need to set anything up at all on the Hardware 
tab, and yet N1MM would still send CW through the serial port?

Changing the Subject of the thread to better reflect this discussion.

----- Original Message ----- 
From: "Dave Hachadorian" <k6ll at arrl.net>
To: "SCCC reflector" <sccc at contesting.com>
Sent: Monday, November 08, 2010 8:53 AM
Subject: Re: [SCCC] ARRL SS CW NE6I


>> On Sunday morning, N1MM software defaulted to SSB when I booted
>> it up. I
>> didn't realize it and struggled with why it wouldn't send CW to
>> the rig.
>> Arghh!
>> 4) After correcting that, N1MM also decided to keep telling me
>> it lost
>> communication with the radio. (It didn't though...it was
>> sending CW just
>> fine.) I finally figured out that I could kill that error by
>> clicking on
>> Cancel when the error message popped up.
>
> This combination of symptoms suggests that N1MM couldn't find
> your radio's RS-232 connection.  The program will still do cw
> keying without the rig control working.  Does the N1MM frequency
> follow your rig's vfo frequency, band, and mode?
>
>
> Dave Hachadorian, K6LL
> Yuma, AZ
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> .
>
> _______________________________________________
> SCCC mailing list
> SCCC at contesting.com
> http://lists.contesting.com/mailman/listinfo/sccc