[SD-User] SD V19.22 Released

[Alister Watt]

Hi Paul,
I have just tried the 100uF capacitor across the reset line modification and that seems to iron out any wiggling of the reset line so my Winkey clone is now detected. Will do some further testing once the capacitor is soldered in place.
CWDTRON and KEYDTRON etc did not seem to sort it out.
The Winkey clone is using software written by K3NG and it is excellent.
73,
Alister
________________________________
From: SD-User <sd-user-bounces at contesting.com> on behalf of Paul O'Kane <pokane at ei5di.com>
Sent: 04 December 2017 21:32
To: sd-user at contesting.com
Subject: Re: [SD-User] SD V19.22 Released

Yes, V18.21 is 18 months old, and there's been many
changes in the meantime, including some of the code
relating to WinKey.

SD V19.22 works reliably with original WinKey units.
With WinKey clones, some experimentation with
parameters may be needed.

Please try these commands

CWDTRON & CWDTROFF - toggle DTR on the CW port
CWRTSON & CWRTSOFF - toggle RTS on the CW port

The default is OFF for both DTR and RTS as they
are not needed by WinKey, but one (or both) may
be needed for WinKey clones.

In any case, it's clear that I need to integrate
these functions into the SETUP command for WinKey.

73,
Paul EI5DI


On 04/12/2017 19:58, Alister Watt wrote:
> Hi Paul,
> Has anything changed on the CW port software since V18.21? The last
> versions I have tried, V19.21b and V19.22 do not reliably detect my
> Winkeyer clone. It beeps as if the power or a reset command is sent on
> initialise, and SD doesn't print Winkey V23 detected.
> I have tried using V18.21's SD.INI file and an ini file from Bryn
> without success.
> 73,
> Al

_______________________________________________
SD-User mailing list
SD-User at contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user