[SECC] K3 and N1MM

[Ted Bryant]

Scott,

Here are the settings in N1MM I'm using on my K3:

Baud rate: 19,200
No Parity
8 data bits
1 stop bit
DTR - Always Off
RTS - Always Off

Make sure the baud rates match between the K3 and com port. The only
interface needed is a straight RS232 cable.  Be sure it is not a null-modem
cable.

73, Ted W4NZ

  -----Original Message-----
  From: secc-bounces at contesting.com [mailto:secc-bounces at contesting.com]On
Behalf Of Scott Weiss
  Sent: Monday, August 08, 2011 11:04 PM
  To: secc at contesting.com
  Subject: [SECC] K3 and N1MM


  Hello to all,
    Looking for help with interfacing my K3 with N1MM. I've read that there
is no need for the interface and would like to know the settings required on
my K3 and N1MM.
                                         Thank you and 73's,
                                                  Scott N2WF
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.contesting.com/pipermail/secc/attachments/20110809/a2414c48/attachment.html