[Skimmertalk] Aggregator from Flex/SDR Bridge Slices ?
k3ukandy at gmail.com
Sun Jul 20 17:44:36 EDT 2014
I never tried the secondary tab before,forgot it was there. yes, it works
fine with the different Telnet ports established by SDR Bridge for each
Flex 'slice" . Accuracy of the frequency seems good and less "fussing" with
a audio IF off-sets than is required with PowerSDR. So, I'm assuming many
others have already figured this out...but I can confirm that a Flex 6500
can send 4 CW Skimmer streams from four different bands to the RBN via RB
On Sun, Jul 20, 2014 at 4:47 PM, Pete Smith N4ZR <n4zr at contesting.com>
> Does it involve 4 separate instances of CW Skimmer, Andy? If so, you
> could set each one to a different port and feed them through Aggregator's
> secondary Skimmer input, I believe.
> 73, Pete N4ZR
> Check out the Reverse Beacon Network at http://reversebeacon.net,
> blog at reversebeacon.blogspot.com.
> For spots, please go to your favorite
> ARC V6 or VE7CC DX cluster node.
> On 7/20/2014 3:19 PM, Andrew O'Brien wrote:
> The Flex 6500 works well with SDR Bridge and provides 4 bands of CW Skimmer
> spots . How would I go about sending all four bands to the Reverse Beacon
> Network? I have previously configured Aggregator for one band, not sure
> about 4.
> Andy K3UK
> Skimmertalk mailing listSkimmertalk at contesting.comhttp://dayton.contesting.com/mailman/listinfo/skimmertalk
More information about the Skimmertalk