[Skimmertalk] CW Skimmer Telnet command to set sampling rate?

[Pete Smith N4ZR]

Dick, to the best of my knowledge, the only Telnet commands implemented 
are those shown in the "Telnet Commands" section of the CW Skimmer Help 
file - which does not include a sample rate command. The CW Skimmer.ini 
file has a section for each type of radio.  The one for the SoftRock 
looks like this:

RigNo=1
[sdrSR]
SignalRate=96000
CenterFreq=14040000
CenterOffset=0

Since the ini file specifies the sample rate (signal rate), it should be 
possible to create a batch file that would stop the software, edit the 
sample rate to a new value, and restart.

You don't mention if you are using one of the multi-band Softrocks, but 
if so you might want to look at SkimScan SR by W3OA, to be found at 
http://dickwilliams.byethost17.com/SkimScanSR.html?i=1. While it does 
not provide for changing the sample rate, it offers the ability to 
band-hop on a variety of user-programmed schedules.  It's a very clever 
piece of work.

73, Pete N4ZR
Download the new N1MM Logger+ at
<http://N1MM.hamdocs.com>. Check
out the Reverse Beacon Network at
<http://reversebeacon.net>, now
spotting RTTY activity worldwide.
For spots, please use your favorite
"retail" DX cluster.

On 10/5/2016 3:06 AM, Dick Green WC1M wrote:
> Hello all.
>
>   
>
> Is there a Telnet command for CW Skimmer to set the Sampling Rate in
> SoftRock mode?
>
>   
>
> I'm able to use the SKIMMER/LO_FREQ command to set the LO frequency, but
> there doesn't seem to be a similar command to set the sampling rate. Is it
> unimplemented or just undocumented (I should be so lucky.)?
>
>   
>
> 73, Dick WC1M
>
>   
>
>   
>
> _______________________________________________
> Skimmertalk mailing list
> Skimmertalk at contesting.com
> http://dayton.contesting.com/mailman/listinfo/skimmertalk
>