Found the problem - something dumb - Ethernet cable not properly seated in switch

73, Pete N4ZR
Check out the Reverse Beacon Network 
at <http://reversebeacon.net>, now 
spotting RTTY activity worldwide. 
For spots, please use your favorite 
"retail" DX cluster.

This morning, when I went to restart my RBN node after last night's thunderstorms, the startup routine seemed to be normal, but neither CW or RTTY Skimsrv will start, both indicating that they can't find the receiver.  My router doesn't show either receiver's IP address as "active.".  Antenna was disconnected during the WX, and the RP was powered down, so I think lightning damage is unlikely  I've looked at the SD card in a card reader and it looks normal; tried another known good one, no change.  Verified that the K3IT interface dlls are properly titled.

Trouble-shooting suggestions urgently needed!

-- 
73, Pete N4ZR
Check out the Reverse Beacon Network 
at <http://reversebeacon.net>, now 
spotting RTTY activity worldwide. 
For spots, please use your favorite 
"retail" DX cluster.

_._,_._,_

---

Groups.io Links:

You receive all messages sent to this group.

View/Reply Online (#4681) | Reply To Group | Reply To Sender | Mute This Topic | New Topic

Your Subscription | Contact Group Owner | Unsubscribe [n4zr@comcast.net]

_._,_._,_