? and / keys (fwd)

[H. L. Serra]

TO: Tentec Engineering

Any chance to get the command set changed so we can use N6TR's trick 
software with our OMNI VIs? (Please read below.) Please let me know. 
73, Larry N6NC 
(Tentec owner for 27 years)


---------- Forwarded message ----------
Date: Wed, 8 Jan 97 15:40:31 PST
From: LarryX Tyree contractor for brentc <larrytx@co.intel.com>
To: hlserra@pwa.acusd.edu
Cc: trlog@contesting.com
Subject: Re: ? and / keys

> Tree- Any hope of getting the shift keys to RIT the Tentec OMNI VI, or 
> any ICOM rigs? 73, Larry N6NC

There is about exactly zero chance of getting it in the Icom radios.

There is maybe a slightly better chance of getting it in the Ten-Tec
radios, but only after they add new commands to their firmware to allow
this type of function.

The reason I say there is some chance with the Ten-Tec, is that if 
enough of you Omni owners complain to Ten-Tec about this feature,
they might actually respond.

They need to add commands that will bump the RIT up or down 10 or 20 hz
per command.  Their scheme of reading the offset, adding or subtracting
a incremental amount, and then writing the new frequency simply takes
too long over the port.  The Kenwood radio does this with a 3 byte
command RD; or RU; (RD - down, RU - up). 

I think TenTec should support the kenwood command set (in addtion to the 
existing one).  But, I am not the engineering manager there.

I doubt Icom would ever respond.

73 Tree
tree@contesting.com


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 w9tw@contesting.com
Sponsored by:             Akorn Access, Inc & KM9P