[TenTec] RE: Fuzzy Audio in the Scout/Argo & Mobile Antler Question

[William K Hibbert]

Well, after all else failed to help, I wired the cord for a Shure 444
dynamic mike, and the problem went away.  

This got me thinking that the problem must have been RF into the electret
condenser mike element, which now posed the question, "Why didn't the
fuzz change when I went to the antlers at the other end of the lot???"

Then I pulled the plug on the KB2YTW/B 10 Meter beacon, and tried the
hand mike again.  NO FUZZ !!!, It was RF, but not from the Argo.  

So, until the new site is ready for the beacon, I will use the Shure mike
in the house, and the Ten Tec mike in the car.

Next question: Not being able to put ANY holes in the car (company car),
how would you run your Argo in the mobile???

72/73, Keith, WB2VUO, QRP-L #582, scQRP 40, Tech Specialist (ARRL/WNY), 
ARRL Life Member, VP/BARK, Beacon Chaircritter, Rochester VHF Group
Trustee, KB2YTW/B 10 Mtr QRPp Beacon (250 mW @ 28.2870 MHz)
"In the Depths of the Great Bergen (NY) Swamp...FN13ac"
Packet - wb2vuo@w2im.#wny.ny.usa.noam
Email  - wb2vuo@juno.com


--
FAQ on WWW:               http://www.contesting.com/TenTecFAQ.html
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Sponsored by:             Akorn Access, Inc. & N4VJ / K4AAA