[TenTec] Omni VI+

[Robert D. Edmondson]

Lynn,
	I use the Heil Pro-set with the HC-5 element & it works fine with my Omni
VI.  My settings are:

	Mic Gain at 9
	GN 05
	DLY 02
	AV 04

	Hope the resistor modification corrects your problem.

					73's Doyle/N4VV

----------
> From: L. L. Lamb <W4NL-KA4S@worldnet.att.net>
> To: tentec@contesting.com
> Subject: [TenTec] Omni VI+
> Date: Thursday, November 13, 1997 12:58 PM
> 
> Good morning.....
> 
> 
> As said, I use the Heil Pro-set with the HC-4 and have tired the HC-5
with
> other rigs. The HC-4 seems better with my voice.  The mike gain is good
at
> the 9 O'Clock position.  The VOX gain is set at the "15" position and on
> the ragged edge of not being enough.  I've played around with the avox
and
> delay levels, and while they have some effect, it's hardly where I wish
it
> to be.  
> 
> The question being, if I change the resistors would I not create more
gain
> for my mike into the audio input of the tx and have to run the mike gain
> lower while not increasing the VOX gain?  I say this since Ten Tec tells
me
> the VOX gain is picked up after and is part of this audio amp circuit. 
The
> Heil is used by others with completely different results vis a vis have
to
> run the mike gain at much higher levels, etc.  All I need is more VOX
gain!!
> 
> Any comments?
> 
> 73, Lynn W4NL
> W4NL-KA4S@worldnet.att.net
> 
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm