[TenTec] TenTec Model 255 Power Supply

[kevin walker]

I had some AC ripple in my model 255 power supply so I set out to
replace the electrolytics.  I doing so I beleive I mixed up a connection
on a board in the power supply. On power up I got a bit of smoke - hate
when that happens ;(

So, I have no schematic and was wondering if someone can point me in the
right direction.  For starters the connections I mixed are a couple of
jacks, one has three pins and has yellow wires, the other is 2 pins and
has green wires.  I thought is was all one connector when I disconnected
it.  For a point of referrence, this board has the connection that goes
to the lamp and the amp meter on the front panel.

I'm thinking I blew the two transistors on the heatsink in back, the
2n5301's
and I'm not sure on the others.  


73,

HF-less in Chicago.

Kevin/KB9NUN

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm