[TenTec] Corsair II AGC Success!!

[Bahr, Casey]

Hi all,

I may have been asleep at the switch (again) and missed if anyone 
mentioned a similar AGC pop fix for the Omni Ds. My Omni-C really
has quite an ear stabber with a strong incoming signal. If it's 599+
I can pull out the RF knob to attenuate and that usually takes care
of it, but that is not a good solution for the mid-range.

73,

Casey Bahr, KS7J, FISTS #3648, CC #450, FNW #1
Trustee, FISTS Northwest, K7FFF, FISTS #4400, CC #457
http://www.imagina.com/webpages/casey/k7fff
Vista Valley FISTS CW Club, K6FFF, FISTS #4444
http://www.angelfire.com/ma/k6ffffists

> -----Original Message-----
> From:	Tom Cooper [SMTP:cooper@gmpvt.com]
> Sent:	Friday, July 10, 1998 5:00 AM
> To:	tentec@contesting.com
> Subject:	[TenTec] Corsair II AGC Success!!
> 
> 
> I soldered a 620 ohm resistor across R45 (3.3K) and I now have only the 
> slightest hint of a pop on very strong signals, certainly not enough to be
> 
> a bother.  I might try a 1K trim pot the next time I have the radio open,
> but
> for now I am satisfied with the result, and it couldn't be an easier fix.
> 
> Try it, you'll like it!
> 
> Tom  W1EAT  
> 
> 
> --
> FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
> Search:                   http://www.contesting.com/km9p/search.htm

--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm